180 Parameters
Differences in the default values between 50 Hz and 60 Hz
supply frequency settings
Parameter
changes the drive
parameter default values according to the supply frequency, 50 Hz or 60 Hz. The bit
is set according to the market before the drive is delivered.
If you need to change from 50 Hz to 60 Hz, or vice versa, change the value of the bit
and then do a complete reset to the drive. After that you have to reselect the macro to
be used.
The table below shows the parameters whose default values depend on the supply
frequency setting. The supply frequency setting, with the type designation of the
drive, also affects Group
parameter values though these parameters
are not listed in the table.
No
Name
bit
50 Hz
bit
60 Hz
1500.000
1800.000
1500.000
1800.000
1500.0
1800.0
-1500.00 rpm
-1800.00 rpm
1500.00 rpm
1800.00 rpm
-50.00 Hz
-60.00 Hz
50.00 Hz
60.00 Hz
ACQ80 FW.book Page 180 Thursday, February 14, 2019 11:33 AM
Summary of Contents for ACQ80-04 Series
