ABB ACQ80-04 Series, Firmware Manual

Page: 21 / 270

Start-up, control with I/O and ID run 21
Navigate to the Options menu and set the
frequency/speed reference. Use and to change
the value.
Press
( OK ) to accept the new setting, or press
( Back ) to go back to the previous view without making
changes.
Note: References can be provided only in local mode. In
remote mode, fieldbus speed reference can be provided
only if parameter
79.40 MPPT reference is disabled.
When MPPT reference is enabled in remote mode, drive
calculates the speed/frequency reference internally. For
information on MPPT, see section
MPPT functionality on
page 34 .
Press Start .
Make sure that the motor is running in the required direction. The direction symbol is
displayed in the home page.
indicates forward direction
indicates reverse direction.
Press Stop .
If you want to make a backup of the settings, navigate to
Main menu and select Backup . You can restore
and back up the data between drive and panel.
Select the option and press ( OK ) to accept or press
( Back ) to go back to the previous view without
making changes.
The first start setup is complete and the drive is ready for
use. The home view Shows values of selected signals.
2 – Additional settings
Macro/start-stop reference, and limit settings
You can make any additional changes to the macro, ramp, and limits, if required.
Macro settings
Navigate to the Main menu and select I/O
connection .
Select the desired macro. Use and to move the
cursor left and right.
Press
( OK ) to accept or press ( Back ) to go
back to the previous view without making changes.
Notes:
• Changing the macro resets all settings to the default values of the selected macro and
updates the I/O signals used in the drive.
You can see the currently used I/O signals
in the menu.
0.0Hz
0
0
Loc
10.0 Hz
0.00
Hz
I
PID
ACQ80 FW.book Page 21 Thursday, February 14, 2019 11:33 AM