Commissioning
System Manual
│102
6.4
Commissioning a system — Step 3: Searching and certifying
6.4.1
Overview
1. Reconnection with the "Smart Access Point" after
commissioning.
see chapter 6.4.3 “Reconnect the
"Smart Access Point"“ on page 105
2. If there is no router with a DHCP function in the system,
enter the IP address of the PC in the IP address range of
the ABB-Welcome IP system.
■
see chapter 6.4.2 “Preliminary
information: Adjusting IP addresses
to a PC“ on page 103
■
see chapter 6.4.4 “Adding via
automatic search“ on page 108
3. Searching and certifying devices.
see chapter 6.4.4 “Adding via
automatic search“ on page 108
4. Backing up the system.
see chapter 6.4.6 “Backup / restore the
project“ on page 111
The actual commissioning process of the system is complete after the system is backed up. The
system is ready to run.
Additional steps
The following points serve for completing the system and are performed only when necessary.
■
Finishing entries of names / bell buttons,
■
Entries of names for outdoor stations with display / indoor stations / concierge stations,
see chapter 6.9 “Setting up name entries in the IP touch 5" outdoor station“ on page
124.
■
Doorbell buttons, see chapter 6.8 “Setting up the doorbell buttons of the "IP pushbutton
outdoor station"“ on page 122.
■
Adding the following devices manually: IP switch actuator, see chapter 6.5 “Adding devices
manually in the "Smart Access Point"“ on page 112.
■
Certifying an IP switch actuator, see chapter 6.5 “Adding devices manually in the "Smart
Access Point"“ on page 112.
■
Deleting devices, see chapter 6.6 “Delete device in the "Smart Access Point" “ on page 116.
■
Resetting the system, see chapter 6.7 “RESET (Reset system / devices)“ on page 117.
■
Changing physical addresses later, see chapter 6.10 “Change devices / Change physical
address“ on page 137.
