A&D FC-50Ki, Instruction Manual

Page: 39 / 64

37
010 010 010 010
q
Upper Limit.
0
00
0
!
Enter via the 10-key pad.
Use the - or
.
key to “set minus value.
q
Lower Limit.
0 00 0
!
Enter via the 10-key pad.
Use the - or
.
key to set minus value.
q
A Beeper With Comparator Results.
These are beeps for the comparator, not for the key
operation.
000
000 000
000
!
All Comparator Beepers are OFF.
Example:
The OK beep sounds – HI & LO doesn't
sound. The scale will beep continuously
when display meets OK condition.
q
Factory Use.
0 00 0
!
This setting should be “
0
”.
F-06-X/F-07-X/F-08-X Data Output F-06-X/F-07-X/F-08-X Data Output F-06-X/F-07-X/F-08-X Data Output F-06-X/F-07-X/F-08-X Data Output
f-06- X for standard RS-232C,
f-07- X for Ch.1 (PORT 1) and
f-08-
X for Ch.2 (PORT 2).
q
Data Out Mode
0 00 0
!
Key mode: Data is sent by pressing the PRINT key.
+ command mode.
1 11 1
Stream mode: Data is sent continuously.
command mode cannot be used.
2 22 2
Auto-print mode A: Data is sent if the weight display is stable
at +5d (weighing display division) and above.
+ command mode.
3 33 3
Auto-print mode B: Data is sent if the weight display is stable,
at ±5d (weighing display division) and above/below.
+ command mode
4
44
4
Command mode only.
f-05-03 f-05-03 f-05-03 f-05-03
f-05-04 f-05-04 f-05-04 f-05-04
f-05-05 f-05-05 f-05-05 f-05-05
000
000 000
000
0
00
0
= Beeper OFF
1
11
1
= Beeper ON
HI LO
OK
f-05-06 f-05-06 f-05-06 f-05-06
f- f- f- f-
X
-01 -01 -01 -01
06 06 06 06
07
07 07
07
08 08 08 08