User manual
Extreme example:
an incline of 10-12% at an altitude of
500 metres, a total weight of 120 kg,
loose terrain, a maximum assistance level,
a travelling speed of < 10 km/h and a
cadence of 60 rpm mean operation in an
unfavourable range at low efficiency and
travelling range and, at the same time, high
heat generation. This will lead to a reduction
of the drive power.
Tip:
By selecting a lower gear with higher
cadence, the "Tour" or "Eco" travel mode
and/or a reduced level of assistance and/or
taking a short break (during which the drive
can cool down again), you can continue to
cycle at optimal performance.
The motor must never be externally
"forcibly cooled" using water! This may
cause damage and does not provide very
much cooling since the inside of the motor
in particular becomes hot.
5.5 Motor
The drive wheel of your Pedelec can be
removed from the bicycle frame at any time,
such as for cleaning or in case of a puncture.
Proceed extremely carefully when removing
the drive wheel and when remounting it
afterwards and, in particular, observe the
manufacturer's information and instructions
for the various components fitted to the
wheel, especially the brake disk. (Note: For
better clarity, the following charts only show
the drive motor integrated in the wheel, but
not the complete drive wheel).
5.5.1 Removing the drive wheel
Record or make a mental note of the
cable installation and the fixing points for
the cable fixers before removing the drive
wheel. First loosen and remove all cable
fixers attaching the cable [16] coming from
the motor and cables and supply lines for
other components to the bicycle frame.
Then disconnect the plug [15] on the motor
cable [16] from the socket [17] on the
battery cable. Loosen the two nuts [18] or
the quick release used for fixing the wheel
to the frame so that the entire wheel can be
removed from your Pedelec's frame.
Mark or make a mental note of the
position of the torque support [20]. It must
be reattached in exactly the same position
removal when fitting the wheel later.
Never hold or transport the removed
wheel by the cable [16] coming from the
motor! There is a risk of breaking the cable.
Summary of Contents for Orsted
Page 1: ...1 Operating instructions rsted...
Page 39: ...39...
