A1S Group Evo1-MCP 1, Technical Manual

Page: 24 / 84

Back to contents
• It is important to check the motor cable is correctly wired into the Motor
control board {MCB) the power+ and - terminals and the brake out + and -
Incorrect wiring will damage the motor and board.
• If the motor control board {MCB) is to be install remotely from the curtain head
box then the motor cable must be fire protected. It is recommended to install
the MCB onto the curtain head box.
• The Multi Control Panel can power upto 4 motors.
• The sequence below must be adhered prior to connecting the Control Panel to
the mains supply.
• Turn the key switch to the test position.
• Remove the main fuse in the bottom left of the board at the mains input
• Connect the mains supply cable.
• Replace the main fuse.
• The MCB will start up and go through its test sequence and the green power
light will illuminate, the panel will then start to beep and the red alarm light will
illuminate.
• Flameshield Evo 1 Curtain Control will display on the LCD screen.
• If the low battery fault is illuminated this will turn off once the mains supply is
connected and the panel charges the batteries to the required voltage.
• The MCB will illuminate
• Turn the test key to the stand by position the red alarm light will turn off and
the audible beep will stop, all curtain connected to the Control Panel will now
start to retract to the headbox.
• The dip switches must now be set.
24