RS-232 Protocol & Telnet Commands
COMMAND
DESCRIPTION
$NET_MAC?
Display the unit’s MAC address.
$NET_MASK?
Display the current Netmask address.
$NET_STATIC_
GATE N1
Set the static Gateway address.
N1
= X.X.X.X [X = 0~255]
$NET_STATIC_
GATE?
Display the static Gateway address.
$NET_STATIC_IP
N1
Set the static IP address.
N1
= X.X.X.X [X = 0~255]
$NET_STATIC_IP?
Display the static IP address.
$NET_STATIC_
MASK N1
Set the static Netmask address.
N1
= X.X.X.X [X = 0~255]
$NET_STATIC_
MASK?
Display the static Netmask address.
$PATTERN N1
Select the test pattern to output.
N1
= 1~56
$PATTERN?
Display the current test pattern selection.
$RX_DDC N1
Enable or disable the DDC bus for the HDMI input (Rx).
N1
= ON, OFF
$RX_DDC?
Display the DDC bus state for the HDMI input (Rx).
$RX_HOTPLUG
N1
Set hot plug value for the HDMI input (Rx).
Available values for
N1
:
OFF
[Set hot plug low]
ON
[Set hot plug high]
TOGGLE [Toggle hot plug low→high]
$RX_HOTPLUG?
Display the current hot plug state for the HDMI input (Rx).
$RX_HOTPLUG_T
N1
Set the hot plug time (in milliseconds) for the HDMI input (Rx).
N1
= 50~500 [Incremented in 50ms steps]
$RX_
HOTPLUG_T?
Display the current hot plug time (in milliseconds) for the HDMI
input (Rx).
$RX_PC_TOL N1
Set PC source clock detection tolerance for the HDMI input (Rx).
N1
= 1~10 [1/1000 ~ 10/1000]
$RX_PC_TOL?
Display the PC source clock detection tolerance for the HDMI
input (Rx).
20
