Unit Object Commands
www.3ware.com
84
In the above example, the RAID-6 unit
u0
has 2 parity drives. Currently, it has
two REBUILDING drives; one is in the active rebuilding state and another is
in the paused rebuild state. The unit is also in the paused VERIFY state. Like
the output of the
/cx show unitstatus
command, the top-level unit status and
percentage show the composite unit status and composite rebuild percentage.
/c
x
/u
x
show
attribute
[
attribute
...]
This command shows the current setting of the specified attributes. One or
many attributes can be requested. Specifying an invalid attribute will
terminate the loop. Possible attributes are: initializestatus, name (9000 series),
autoverify (9000 series), cache, ignoreECC (9000 series), identify (9000
series SX/SE/SA only), qpolicy (9000 series SX/SE/SA only), rapidrecovery
(9000 series SE/SA only), rebuildstatus, serial (9000 series), status, storsave
(9000 series SX/SE/SA only), verifystatus, and volumes (9000 series).
/cx/ux show autoverify
This feature only applies to 9000 series controllers.
This command shows the current autoverify setting of the specified unit.
Example:
//localhost> /c0/u0 show autoverify
/c0/u0 Auto Verify Policy = off
/cx/ux show cache
This command shows the current write cache state of the specified unit. (It
provides the same information as the command /c
x/
u
x
show wrcache.)
Example:
//localhost> /c0/u0 show cache
/c0/u0 Write Cache State = on
/cx/ux show wrcache
This command shows the current write cache state of the specified unit. (It
provides the same information as the command /c
x/
u
x
show cache.)
Example:
//localhost> /c0/u0 show wrcache
/c0/u0 Write Cache State = on
Summary of Contents for 720-0192-00
Page 3: ......
