Chapter 2. CLI Syntax Reference
37
3ware SAS/SATA RAID Controller CLI Guide, Version 9.5.2
/c
x
show
attribute
[
attribute
...]
This command shows the current setting of the specified attributes on the
specified controller. One or many attributes can be specified. Specifying an
invalid attribute will terminate the loop. Possible attributes are: achip,
allunitstatus, autocarve (9000 series SX/SE/SA only), autorebuild (9000
series SX/SE/SA only), bios, carvesize (9000 series SX/SE/SA only), driver,
drivestatus, firmware, memory, model, monitor, numdrives, numports,
numunits, ctlbus (9000 series SX/SE/SA only), ondegrade (9500S), pcb,
pchip, qpolicy, serial, spinup (9000 series), stagger (9000 series), and
unitstatus.
Example:
To see the driver and firmware installed on controller 0, enter the
following:
//localhost> /c0 show driver firmware
/c0 Driver Version = 2.x
/c0 Firmware Version = FE9X 3.x
(In the sample output above, “x” will be replaced with the actual version
number.)
/cx show achip
This command reports the ACHIP (ATA Interface Chip) version of the
specified controller /c
x
.
Example:
//localhost> /c0 show achip
/c0 ACHIP Version = 3.x
/cx show allunitstatus
This command presents a count of total and Not Optimal units managed by
the specified controller /c
x
. For more about the meaning of Not Optimal, see
“Shell Object Commands” on page 26.
Example:
//localhost> /c0 show allunitstatus
/c0 Total Optimal Units = 2
/c0 Not Optimal Units = 0
/cx show autocarve
This feature only applies to 9000 series SX/SE/SA controllers.
This command reports the Auto-Carve policy. If the policy is
on
, all newly
created or migrated units larger than the carvesize will be automatically
carved into multiples of carvesize volumes plus one remainder volume. Each
volume can be treated as an individual drive with its own file system. The
Summary of Contents for 720-0192-00
Page 3: ......
