Chapter 2. CLI Syntax Reference
67
3ware SAS/SATA RAID Controller CLI Guide, Version 9.5.2
/c
x
add verify=
ddd:hh:duration
This command adds a new task slot to the Verify Task Schedule on the day
ddd
(where ddd is Sun, Mon, Tue, Wed, Thu, Fri, and Sat), at hour
hh
(range 0 .. 23), for a duration of
duration
(range 1 .. 24) hours. A maximum of
seven verify task slots can be included in the schedule. This command will
fail if no (empty) task slot is available.
Example:
//localhost> /c1 add verify=Sun:16:3
Adding scheduled verify to slot 3 for [Sun, 4:00PM, 3hr(s)] ... Done.
In this example, a verify task slot is added to the schedule so that verifies can
be executed on Sundays at 16 hours (4:00 PM) for a duration of 3 hours.
Setting Up a Verify Schedule
Setting up a verify schedule requires several steps, and several different CLI
commands in addition to
/cx add verify.
To set up the verify schedule you want to use, follow this
process:
1
Use the
/cx show verify
command to display the current schedule for
verify tasks. (For details, see page 55.)
2
If any of the scheduled tasks do not match your desired schedule, use
the
/cx del verify
command to remove them. (For details, see page 69.)
3
Use the
/cx add verify
command to create the verify schedule slots you
want (described above.)
4
Use the
/cx set verify=enable
command or the
/cx set verify=advanced
to enable the schedule (this enables all rebuild schedule slots). (For
details, see page 72.)
5
Use the
/cx/ux set autoverify=on
command to turn on autoverify for each
unit you want to follow the schedule. (For details, see page 92.)
Note:
This Verify Task Schedule is used when /cx set verify=advanced, for 9650SE
and 9690SA controllers running firmware 9.5.1 or later, and for earlier controllers
when /cx set verify=enabled.
If you have a 9650SE or a 9690SA running firmware 9.5.1 or later, and would prefer
a simpler verification schedule, consider using the /cx set verify=basic command
to specify a weekly day and time and make sure that the auto-verify policy is set for
your RAID units. For more information, see “/cx set verify=basic [pref=ddd:hh]” on
page 74.
Summary of Contents for 720-0192-00
Page 3: ......
