Port Object Commands
www.3ware.com
108
Drive Ports
indicates the number of physical ports on the drive. Can be 1 or 2,
depending on whether the drive is a dual-ported drive. SAS drives can be
either single or double ported, while SATA drives have only one port.
Drive Connections
indicates the number of connections from the controller
to the drive. Can be either 1 or 2.
Additional information is available using the
/cx/px
show all command.
Example:
//localhost> /c3/p4 show driveinfo
/c3/p4 Drive Type = SAS
/c3/p4 Interface Type = Direct
/c3/p4 Drive Ports = 2
/c3/p4 Drive Connections = 1
/cx/px show firmware
This command displays the firmware version of the drive attached to the
specified port.
Example:
//localhost> /c0/p5 show firmware
/c0/p5 Firmware Version = 65.13G65
/cx/px show identify
This command only applies to 9000 series SX/SE/SA model controllers. This
feature requires a supported enclosure.
This command shows whether the LED of the drive attached to the specified
port is set to
on
or
off
. For details, see “/cx/px set identify=on|off” on
page 115.
Example:
//localhost> /c0/p5 show identify
/c0/p5 Identify Status = on
/cx/px show lspeed
This command only applies to 9000 series SX/SE/SA model controllers.
This command displays the maximum SATA link speed supported by the
drive attached to the port and the present SATA link speed setting.
Example:
//localhost> /c0/p5 show lspeed
/c0/p5 SATA Link Speed Supported = 3.0 Gb/s
/c0/p5 SATA Link Speed = 3.0 Gb/s
Summary of Contents for 720-0192-00
Page 3: ......
