3Com OfficeConnect WX1200, Command Reference Manual

Page: 417 / 646

set spantree portvlancost 417
set spantree
portvlancost
Changes the cost of a network port or ports on paths to the STP root
bridge for a specific VLAN on a wireless LAN switch.
Syntax —
set spantree portvlancost port-list cost cost { all |
vlan vlan-id }
„
port-list
— List of ports. MSS applies the cost change to all the
specified ports.
„
cost cost — Numeric value. You can specify a value from 1 through
65,535. STP selects lower-cost paths over higher-cost paths.
„
all — Changes the cost on all VLANs.
„
vlan vlan-id
— VLAN name or number. MSS changes the cost on
only the specified VLAN.
Defaults — The default port cost depends on the port speed and link
type. (See Table 68 on page 393.)
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the cost on ports 3 and 4
to 20 in VLAN mauve :
WX1200# set spantree portvlancost 3,4 cost 20 vlan mauve
success: change accepted.
See Also
„
clear spantree portcost on page 394
„
clear spantree portvlancost on page 395
„
display spantree on page 398
„
display spantree portvlancost on page 403
„
set spantree portcost on page 414