2N Helios IP, Configuration Manual

Page: 55 / 177

2N TELEKOMUNIKACE a.s., www.2n.cz 55/177
Note
The HTTP command sending is available with the Gold or Enhanced
Integration licence only .
Command sent upon activation – set the command to be sent to the external
device (WEB relay, e.g.) upon switch activation. The command is sent via the
HTTP (GET request) and must be as follows:
. E.g.: http://ip_address/path
. http://192.168.1.50/relay1=on
Command sent upon deactivation – set the command to be sent to the external
device (WEB relay, e.g.) upon switch deactivation. The command is sent via the
HTTP (GET request) and must be as follows:
. E.g.: http://ip_address/path
http://192.168.1.50/relay1=off
Tip
In case of use external relay are used next HTTP part no.: 9137410E
commands:
To turn on the switch – (e.g.: http://ip_address/state.xml?relayState=1
) http://192.168.1.10/state.xml?relayState=1
To turn on for pre-defined time (default value is 1.5 s) – http://ip_address
(e.g.: ) /state.xml?relayState=2 http://192.168.1.10/state.xml?relayState=2
To turn off - (e.g.: http://ip_address/state.xml?relayState=0 http://192.
) 168.1.10/state.xml?relayState=0
In case of use external relay are used next HTTP commands part no.: 9137411E
(Symbol X should be replaced with a number of the desired switch):
To turn on the switch – (e.g.: http://ip_address/state.xml?relayXState=1
) http://192.168.1.10/state.xml?relay1State=1
To turn on for pre-defined time (default value is 1.5 s) – http://ip_address
(e.g.: /state.xml?relayXState=2 http://192.168.1.10/state.xml?relay1State=2
)
To turn off - (e.g.: http://ip_address/state.xml?relayXState=0 http://192.
) 168.1.10/state.xml?relay1State=0
Legacy switch code – enable the option to activate the first-listed switch code