P-793H v 2 Support Notes
Fail Tolerance:
Type the number of times (2 recommended) that your P-793H
v2 may ping the IP addresses configured in the
Check WAN IP Address
field
without getting a response before switching to a WAN backup connection.
Recovery Interval:
When the P-793H v2 is using a lower priority connection
(usually a WAN Backup connection), it periodically checks to whether or not it
can use a higher priority connection. Type the number of seconds (30
recommended) for the P-793H v2 to wait between checks. Allow more time if
your destination IP address handles lots of traffic.
Timeout:
Type the number of seconds (3 recommended) for your P-793H
v2 to wait for a ping response from one of the IP addresses in the
Check
WAN IP Address
field before timing out the request. The WAN connection
is considered
“down” after the P-793H v2 times out the number of times
specified in the
Fail Tolerance
field. Use a higher value in this field if your
network is busy or congested.
Traffic Redirect
Settings:
Active
: Enable or disable traffic redirect setup.
Backup Gateway:
The IP address of your backup gateway. P-793H v2
automatically forwards outgoing traffic to this IP address if
Prestige‟s Internet
connection terminates.
Metric
: Enter a number from 1 to 15 to give your traffic redirect route a priority
number. The smaller the number, the higher priority the route has.
You can also configure WAN backup via
SMT Menu 2- WAN Setup
and traffic
redirect via
SMT Menu 2.1- Traffic Redirect Setup.
81
All contents copy right © 2010 Zy XEL Communications Corporation.
