P-793H v 2 Support Notes
Note:
When P-793H v2 works as client, options
“Enable Rate Adaption”
“Transfer Max Rate” “Transfer Min Rate” and “Standard Mode” are not
available to choose. These parameters are then determined by server side.
6. What is the checklist for making a 1-2 Back-to-Back connection over
P-
793H v2?
1. Make sure the two remote P-793H v2s are with Service Mode=2 wire,
and Service Type = Client. The central one is with Service Mode=4
wire, and Service Type = Server.
2. The "Encapsulation", "Multiplexing", "VPI/VCI" option in menu 11 must
be the same for all P-793H v2s.
3. Enter the remote IP following: Remote ones take central one as
gateway.
Note:
This application is realized via One Y cable.( On the Y cable, there should
be
“DSL1” and “DSL2” printed on the offshoot phone cable which guide you to
connect two clients)
7. Setup the P-793H v2 as a DHCP Relay
What is DHCP Relay?
DHCP stands for Dynamic Host Configuration Protocol. In addition to the
DHCP server feature, the P-793H v2 supports the DHCP relay function. When
it is configured as DHCP server, it assigns the IP addresses to the LAN clients.
When it is configured as DHCP relay, it is responsible for forwarding the
requests and responses negotiating between the DHCP clients and the server.
See figure 1.
45
All contents copy right © 2010 Zy XEL Communications Corporation.
