ZOJE A9200L-D4-W-CP, Руководство по эксплуатации

Страница: 33 / 65

-24-
注意:
1.为了防止缝纫机的意外启动，请关掉
电源之后再进行操作。
若机针与旋梭梭尖的间隙太小，会磨 2.
损旋梭梭尖；若间隙过大，会引起跳针。
.若旋梭损坏了，请更换相同型号的旋 3
梭。
Caution:
1.To prevent the unexpected startup
of sewing machine, trim off the pow
-er supply before the operation is co
-nducted.
2.If the clearance between notch on
needle and thread hooking tip of rot
-ating hook is too small, rotating hoo
-k tip may be worn;if the clearance is
excessive,skipped stitch may take p
-lace.
3.It may lead to needle breakage if o
-ver-rotating the eccentric wheel tow
-ards A direction.
图3 0
Fig.3
0
机针和送料同步的调节 (图3 1 )
Adjust the Synchronization of the Needle and Feed(Fig. 31)
25
1.取下橡胶塞①。
2.旋松送料偏心轮②上的两个固定螺钉③，然
后轻微的旋转送料偏心轮②进行调节：要使机
针早于送料时，向A方向旋转；要使机针晚于
送料时，向B方向旋转(标准调节位置：送料牙
从最高位置开始下降到和针板的表面一致时，
机针孔上沿与针板面对齐)。
3.调节完成后拧紧2个固定螺钉③，并装上橡
胶塞①。
1.Remove the rubber plug ①.
2 .Loosen the two set screws ③ of the feed
eccentric cam ②, and then turn the feed ecce
- ntric cam ② slightly to adjust the timing : If m
- ake the needle sooner than material feeding,
rotate toward A direction. If make the needle l
- ater than material feeding, rotate toward B di
- rection. ( The standard of adjustment is whe
- n the feed dog falling from the highest to the
surface of needle plate, the top of the needle
and needle plate should at the same level).
3.Tightening two positioning screw ③ and
assembly the rubber plug ① after adjusting.
注意:
1.为了防止缝纫机的意外启动，请关掉
电源之后再进行操作。
Caution:
1.To prevent the unexpected startup
of sewing machine, trim off the pow
-er supply before the operation is co
-nducted.