Zodiac SIROCCO 110, Руководство по установке

Страница: 19 / 28

18
3. Maintenance
3.1 Maintenance instructions
3.1.1 Monthly checks

check for clogging in the filter:
- wash the filter with warm soapy water,
- rinse it abundantly and dry it,
- replace it if necessary.

check visually that the condensation is drained.
3
.
1.2 Annual checks

check that the electric cable connections, contactors are correctly tightened,
Loose cables may cause overheating of terminals,

check that each command relay, power switch and electronic protection device is operational,

check the adjustment and operation of the Hygro Control if necessary clean the dust inside it using
a jet of air,

clean the whole unit with a slightly damp cloth,

check the cleanliness of the condensation drainage tray and tube,

to improve the operation of the appliance, it is possible to make a visual check of the fouling of the
batteries (evaporator / condenser and hot water) by removing the cover from the appliance
(switched off) . Depending on the condition, clean with a silk brush and a vacuum cleaner.
3.2 Spare parts
Naming Item number Representation
Hygro Control sensor WCE03431
Filter:
Sirocco 55 can be inset
WSD01911
Sirocco 80 can be inset WSD01912
Sirocco 110 can be inset
Sirocco 55 ambient
WSD01913
Sirocco 80 ambient WSD01914
Sirocco 110 ambient WSD01915
Be aware of the following:
On the three-phase Sirocco, via the phase controller (KA4), any modification of the order
of phases on the distribution network or on the existing electrical installation is detected.
The appliance then goes into fault mode (“alarm triggered” led lit), see § 2.1.
The appliance must have a filter fitted when operating.
Appliance powered off and decommissioned!
A general servicing of the appliance is strongly recommended to check the proper
operation of the appliance, maintain its performance, to avoid certain faults and preserve
the building in good condition.
EN