Zodiac NOOSA REEF, Инструкция по эксплуатации

Страница: 54 / 64

SKIMMER BOX INSTALLATION
52
One piece return fitting installation this step
is not to be commenced until there is at
least 60cm of water in the pool.
Before attaching the return fitting to the
pool, it is necessary to cover the threads of
the return fittings with a thin layer of Teflon
tape to ensure a watertight seal.
1/ Using a small piece of cardboard push the
liner back against the metal pool wall to
locate the exact position of the circular cut-
out in the wall, and using a sharp knife
carefully cut a circular hole in the liner (from
the outside) approximately 3mm smaller
than the cut-out in the metal wall.
2/
Fit a cork gasket over the barrel of the
fitting and a rubber gasket between the pool
liner and the metal pool wall, and push the
fitting through the wall from the inside of
the pool.
3/ The remaining rubber gasket and the cork
gasket are now fitted over the barrel fitting
from the outside of the wall, with the rubber
gasket up against the pool wall, the lock nut
is now screwed onto the barrel and
tightened firmly to ensure a watertight seal,
care must be taken to ensure that the
locknut is not over tightened causing the
flange on the barrel to rotate and distort the
liner, if this occurs the lock nut should be
loosened, the gaskets repositioned and the
lock nut re tightened.
4
/ The adjustable directional eyeball fitting,
can now be screwed into the face of the wall
return fitting.The outlet in this fitting (the
return to the pool) should face away from
the opening (the inlet) to the weir skimmer
assembly.
ONE PIECE RETURN FITTING
Universal quick snap
(2) P5346
Screws P7514
Eyeball return
P75042
Complete Skimmer
P5802
Cover P5315
Vacuum plate P5314
Skimmer basket P5316
Skimmer door P5317
Pool wall & liner
Double gasket P5318
Face plate P7506
Single gasket P7518C
Cover plate P73502