Zodiac NOOSA REEF, Инструкция по эксплуатации, Страница: 34 / 64

Continue by inserting the end of each wall channel into
joiner plates. Ensuring that they are firmly inser ted and
leaving a space of
13 mm (ill. A) between each wall channel
of the round sections. Insert and leave a 50 mm
Important:
The wall channels of the straight sections
are shorter (1067 mm). Install the wall channels
by placing them on the inside of the braceless
the joiner plates will hold
the vertical sleeve on either side (ill. C).
frames. In this way, the feet of
space on the straight side (ill.B).
ASSEMBLY
32
Note: The wall channels should be positioned on the mark of the radius
STEP 19.
NOTE:
Only the end radius wall channels are adjustable and have indexing pins.The intermediate wall channels side sections
are not adjustable and are used as the straight sides
You must now assemble the wall channels.This is a three step process.
STEP 1:
Detach the indexing pins attached to the wall channel.
STEP 2:
Identify on the reverse side of the wall channel (while loooking underneath the wall channel) the approximate radius of your pool
and insert the indexing pin into the corresponding hole - refer to illustration “A” above.
STEP 3:
Turn the wall channel right side up and align once again the pin with the corresponding hole. Press down the wall channel onto the
pin to complete the assembly - refer to illustration “B” above. Repeat these steps for each wall channel and indexing system.
STEP 20.
13 mm
-13
50
50 mm
A
B
C
INDEX:
Hole (12) = 3.6mt Pools (w)
Hole (15) = 4.5mt Pools (w)
A
B