Info
Only for mode
2.04
,
3.03
,
3.04
(E2 function =
|
4E
|
)
The highest value determined automatically from two sensor measuring values which
is used as the actual value for the control (unit depending on programming).
0
°
C
Control value
Info
Only for mode
2.04
programmed for averaging (E2 function =
|
3E
|
).
49.9
°
C
Average E1/E2
Info
Current actual value measured at sensor 1 (unit depending on programming).
0
°
C
E1 Actual
Info
Display for
“
actual value 2
”
for operation with two sensors.
Display if function not active:
|
- - - - -
|
0
°
C
E2 Actual
Info
Display of the active target value at which the device operates.
“
Setpoint1
”
Menu
“
Setting
”
“
Setpoint2
”
Menu
“
Setting
”
“
Ext. Setpoint
”
= setting by external signal 0-10 V. With activated manual mode the
display constantly changes between actual value and value for manual mode.
Display for operation with two control circuits:
“
1.Setpoint 1
”
or
“
1.Setpoint 2
”
for control circuit 1
“
2.Setpoint 1
”
or
“
2.Setpoint 2
”
for control circuit 2
0
°
C
Setpoint1
Info
Only for mode
4.02
,
4.03
,
5.02
with setpoint depending on outdoor temperature (E2
function =
|
6E
|
).
100.0 Pa
Setpoint control
Info
Level modulation control output.
In addition to the bar chart, the level of the output voltage is indicated.
The modulation for each control circuit is displayed in operation with two control
circuits:
“
1. Modulation
”
for control circuit 1
“
2. Modulation
”
for control circuit 2
0 %
Modulation
Info
Momentarily status for minimum speed cut off
“
ON
”
= switch off, if Setpoint (+/-
“
Min. speed cut off
”
) is reached.
“
OFF
”
= no switch off that means operation with minimum rate of air.
Display for operation with two control circuits:
“
1. Min. speed cut off
”
for control circuit 1
“
2. Min. speed cut off
”
for control circuit 2
OFF
Min. speed cut off
Operating Instructions
UNIcon MODBUS Master
Programming
L-BAL-E207-GB 1723 Index 003
Part.-No.
52/114