Zgonc Yellow GARDEN LINE 720 YGL N.G. NEW GENERATION, Перевод оригинального руководства пользователя

Страница: 45 / 64

Steering Triggers (if so equipped)
Steering triggers are used to assist in steering the snow thrower. The triggers are
located on the underside of each handlebar. When a trigger is squeezed, it disengages
the drive wheel on that side and allows the snow thrower to turn in that direction. With
the drive clutch engaged, squeeze the right trigger to turn right and squeeze the left
trigger to turn left.
It is easier to maneuver a non running snow thrower with both triggers held in
simultaneously.
Fuel Shutoff Valve
Always operate the snow thrower with the fuel shut-off valve in the OPEN position. Close the valve when you do not use the machine.
Throttle Lever
Move the throttle lever to the right to increase the engine speed; move it to the left to decrease the engine speed. Move the throttle lever
to the STOP position to stop the engine.
Choke
Engage choke by rotating lever to FULL position whenever you are starting a cold engine. As engine warms up, gradually rotate the
choke to the OFF position. Do not use choke to start a warm engine.
m
Never use choke to stop engine.
Primer
Press the primer to pump additional fuel from the carburetor to the cylinder for improved cold weather starting.
Recoil Starter
The recoil starter is on the back side of the engine. Pull the recoil starter handle to start the engine.
Safety Ignition Switch
Insert the safety ignition key for engine to start and run. To stop the engine, remove the key.
Electric Starter & Start Button
The electric starter will start a properly choked and cranked engine when the key is turned (12V DC) or start button (120V or 230V AC) is
pushed.
To start the machine, connect the electric starter to an electric power source with an approved extension cord and press the start button.
m
Thoroughly inspect the electrical cord before using the machine. If the cord is damaged, do not operate the machine. Replace or
repair the damaged cord immediately.
m
Connect extension cord to the electric starter plug-in first and then to a power outlet; disconnect the extension cord from the power
outlet first and then from the machine.
m
To prevent damaging the electric starter, do not run it more than 5 continuous seconds each time you try to start. Wait 10 seconds
between each attempt.
45
D GB