PULSAR
®
PLUS III-S, III-S6, and VI-S SUCTION BLAST CABINETS
Page 33
© 2021 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 30421
7.11.2.9
Use a new inlet gasket and reattach the inlet-
pipe adaptor.
7.11.2.10
Allow time for the caulking to cure before
putting the reclaimer into service.
7.12
Replacing or Field Installing Optional Rubber
Reclaimer Liners in a Pulsar Plus VI-S Reclaimer
Not available for Pulsar Plus III-S (300 cfm reclaimers).
The reclaimer must be designed to accept liners and
have a removable top, as shown in Figure 42.
Figure 42
To replace or install liners, the reclaimer must
be removed from the power module. Lined
Pulsar Plus VI-S reclaimers weigh
approximately 160 lbs. When removing and
installing the reclaimer, it must be adequately
supported and secured to appropriate lift
equipment. Failure to secure and use proper lift
device can result in injury.
Installation Notes:
Make sure at least 6 feet of Stock No. 13089 (2"
adhesive-backed gasket) and one Stock No. 11779
(inlet-pipe gasket) are available to replace compressed
or damaged gaskets on the reclaimer’s lower flange and
inlet pipe.
The inner cone and cone ring are glued in place. Make
sure a multipurpose contact adhesive, such as 3M
®
No.
10 neoprene contact adhesive or equal, is available.
7.12.1
Remove the flex hoses from the reclaimer inlet
and outlet and then remove the inlet-pipe adaptor.
7.12.2
Make a note of the reclaimer’s alignment; the
reclaimer door is facing the power module’s open side.
The reclaimer must be reinstalled facing in the same
direction.
7.12.3
Refer to Figure 43 and remove the four
fasteners securing the reclaimer to the two support
angles. Mark each of the four lower-flange bolt holes for
to assist with reinstallation.
Figure 43
7.12.4
Remove the reclaimer from the power module.
7.12.5
Remove the remaining fasteners, securing the
cone to the lower flange, and then remove the cone, as
shown in Figure 44.
Figure 44
7.12.6
Set the reclaimer top-side-up on a clean, flat,
level surface.
7.12.7
Remove the bolts and nuts, securing the
reclaimer top, and then remove the top (and top liner
and cylinder liner if the reclaimer is currently lined), as
shown in Figure 45.
7.12.8
If the reclaimer is currently unlined, begin at the
installation note preceding Paragraph 7.12.15.
7.12.9
To remove the top liner and cylinder liner, grind
the tack welds from the bottom of the cylinder liner that
secure the liner to the tube, and then slide the cylinder
liner and top liner off the inner tube.
Removable Top
To accept liners, the
reclaimers must have a
bolt-on removable top.
Remove all
remaining fasteners.
Remove cone.
Support Angle (2)
Remove four bolts and nuts
securing the reclaimer flange
to the two support angles.
Nuts and Washers
