PULSAR
®
PLUS III-S, III-S6, and VI-S SUCTION BLAST CABINETS
Page 29
© 2021 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 30421
7.7.3
Pivot the window frame up or down until tension
is off the frame hinges.
7.7.4
Slide the frame to the right to remove. The
hinges separate, as shown in Figure 35.
Figure 35
7.7.5
Replace the frame in reverse order. Slide the
frame as necessary to align the top bolt holes with the
bolts.
7.7.6
Set the window squarely over the window
opening. Make sure that all edges of the window are
centered and overlapping the window gasket, and that
the window is resting on the window support tabs.
7.7.7
Swing the window frame into place and tighten
the frame nuts.
7.8
LED Light Assembly – Figure 36
Use an approved stepladder when servicing the
light assembly. Do not climb on top of the
cabinet. The cabinet top will not support the
weight of a person. Failure can result in injury
and property damage.
7.8.1 Remove LED light assembly
7.8.1.1
Turn OFF electrical power.
7.8.1.2
Remove the four nuts and washers (save them
to reuse) that attach the light assembly to the cabinet,
lift the light off the diffuser, as shown in Figure 36. Set
the light out of the way and within reach of the cord.
Figure 36
7.8.2
Diffuser lens replacement
7.8.2.1
Remove the light assembly, as noted in Section
7.8.1.
7.8.2.2
Lift the diffuser lens off the gasket. Inspect the
gasket and replace it per Section 7.8.3, if the gasket is
compressed or otherwise damaged, per Section 7.8.2,
before centering the new diffuser (smooth side up) over
the gasket.
7.8.2.3
Set the light assembly on the diffuser and
reattach it using the existing nuts and washers.
7.8.3
Gasket replacement
7.8.3.1
Remove the light assembly, as noted in Section
7.8.1.
7.8.3.2
Remove all the old gasket material and clean
the surface of the cabinet.
7.8.3.3
Lay a length of strip gasket along a long edge of
the light opening and cut to length, allowing 3/4
overlap
on each end. Peel the adhesive backing and adhere the
strip gasket to the edge of the opening, as shown in
Figure 36. Press the gasket to bond the adhesive to the
cabinet. Repeat the process on the remaining sides,
compressing the ends to seal
Pivot the frame up or down
until tension is removed
from the hinges.
Support Tabs
Slide the frame to the right
to separate the hinges.
LED Light Assembly
Nut and Washers
Strip Gasket
Diffuser Lens
Smooth side up.
