Zepro Z 45-90, Руководство по установке

Страница: 23 / 68

Z 45/75-90/110 Installation
23 www.zepro.com
4.2 Support frame
1. Measure and mark the midpoint of the vehicle's
rear beam. See Image 19.
2. Bolt or spot-weld the mounting jig onto the rear
beam, so that both centre-points are aligned.
Mounting jig, part no. Model
53704TL Z 45/75
53705TL ZL 45/75
53706TL ZN 45/75
56419TL
Z 45/75 without
sealing strips
56420TL
ZL 45/75 without
sealing strips
3. Position the support frame under the vehicle frame.
4. Raise the lift arms to their highest position.
5. Attach the lift arms to the lugs on the jig. Use the
lift platform’s normal pivot bolts.
6. The support frame should be positioned as high as
possible within the specified C dimension. Adjust
the frame to the ideal height under the chassis.
A workshop jack is helpful. The frame must be
positioned parallel with the floor of the vehicle
body and must not be in contact with the vehicle
frame; there must be a few millimetres of play. If
necessary, adjust the angle of the arms by carefully
operating the lift.
7. Fit the lower part of the chassis bracket on the
support frame. Adjust its position on the frame ac-
cording to the width of the vehicle chassis. Fasten
with six bolts, two angled washers and a fixing plate
placed inside the support frame. Use the M14x35
bolts supplied. Install without tightening.
Image 19. Measure and mark the mid-
point of the rear beam of the vehicle
Image 20. Press, bolt or spot-weld the
mounting jig to the rear beam
Image 21. Mounting jig. See table on the
next page for part number.
Image 22. Fit the lower part of the chas-
sis bracket on the support frame.