Zepro Z 45-90, Руководство по установке

Страница: 25 / 68

Z 45/75-90/110 Installation
25 www.zepro.com
F
Vehicle floor level
Type Flat head 30
mm
F (mm) 75
4.3 Lift platform
1. Check that all included components are clean,
clean where necessary.
2. Lubricate the metal bushings on the upper bear-
ing of the arms. Make sure the small holes on
the inside of the bushings are filled with grease.
Use Zepro lubricant or equivalent.
NOTE!
Carefully lubricate the metal bushings on the
upper bearing of the arms. Make sure the small
holes are filled with grease. After installation of
the platform, the same bearings are also lubri-
cated through the regular lubrication nipples, see
section "14 Lubrication and oil level check" on
page 59.
3. Fit the platform to the arms and fasten the tilt
cylinders to the platform. Use the supplied shafts
and locking nuts. Tightening torque: 25 Nm.
NOTE!
The tilt cylinders should be adjusted before fixing
to the platform.
4. Test the lift by carefully raising it to the vehicle
floor level and tilting it to the vertical position.
Check the position in relation to the rear beam
and side posts of the vehicle. See Image 27.
NOTE!
The platform underhang (F) varies according to
platform type and this should be taken into ac-
count when fitting the top edge seal.
4.4 Purging the cylinders
Purge the lift cylinders by fully lowering the platform a
few times. You may have to lift the truck to fully lower
the platform.
The tilting cylinders can be purged by raising the
platform fully against the vehicle body and then tilting
all the way down.
Image 26. Fit the platform with the
shafts and locking nuts provided.
IMPORTANT
!
Oil may need to be topped up during purging of the
hydraulic system.
Image 27. Fit the platform to the arms