Zeppelin 1x8 Cabinet, Руководство по сборке

Страница: 22 / 52

22
34. Remove the clamps from the ports, set the cabinet on its back, and check the front for square
again. If the cabinet is not square, place the baffle back into the cabinet and clamp it tightly into
one of the acute corners.
64
This will pull the whole box perfectly square.
Leave the whole thing alone for at least four hours!
This is a good time to make the hookup cable. Or go to bed, depending on the hour.
35. After the glue is completely cured, remove the baffle and inspect the joints. If any joints are poorly
mated, or if the ports stick out of the back of the cabinet, grind them flush with 60 grit sandpaper.
65
36. Edge Detail: If you want to apply a router detail, now’s the time.
66
There’s only room for a small
chamfer or roundover. (If you don’t want to use a router, you can achieve a similar look simply
with a lot of hand-sanding.) We use a 3/16” roundover bit with a bearing at the bottom. As you
route each edge, be careful to orient the router so that you do not run the bearing across the
screw heads. This will result in blemishes. Round over all the outside edges except the four back
edges.
67
64
65
66 67