Zeppelin 1x8 Cabinet, Руководство по сборке

Страница: 35 / 52

35
11. Place the assembly face down on the table. While holding the grill cloth in its proper place, use
your staple gun to put one staple into the edge of the baffle board in the middle of each side.
Make sure the staple is right in the middle of the baffle board in both directions (up/down and
left/right).
112
12. Re-examine the assembly to make sure the grill cloth lines are still straight (use your speed square)
and check to make sure the back of the grill cloth is still flat against the front of the baffle board.
If so, proceed with placing staples around the edges. Start in the middle of each side and move
to the corners.
113
Alternate sides with each staple. Put the staples in at a 45 degree angle, so that
all the staples aren’t lined up in the middle of the edge.
114
If any staples aren’t seated properly
you can use your hammer to tap them in. Periodically use your speed square to check that the
lines are remaining straight (in both directions). Don’t worry about getting the grill cloth tight on
this step, just concern yourself with getting the lines straight. If you notice some of the lines are
going crooked, pull out the necessary staples and start over. Take your time and you will be
pleased with the results.
13. When you are done stapling and the lines are all straight, cut the long lengths of the grill cloth
from the corners of the baffle board.
115
112
113 114
115