Zeppelin 1x8 Cabinet, Руководство по сборке

Страница: 19 / 52

19
28. Now apply glue to the remaining exposed ends of both the TOP and BOTTOM. Fit four screws
into the remaining SIDE and maneuver them into all four little pilot holes. Align, clamp and screw
the joints (barely snug) one at a time.
51-54
51 52
53 54
25. Add the second clamp right across the joint and apply moderate pressure to hold the joint securely
for screwing.
44
26. With a #2 Philips screwdriver or cordless screw gun, press in hard and drive the two screws
barely snug.
45
You will tighten these later. Note you are setting these screws into end grain, and
it may need a lower clutch setting than you used on the cleats to prevent the screw from spinning
out. DO NOT OVERTIGHTEN!
27. Now attach the BOTTOM to the same SIDE, holding the joint secure with a clamp while driving
the screws barely snug.
46-50
44
45
48 49
50
46 47