47
PUTTING IT ALL TOGETHER
1. Install the Ports: If you chose to leave the Ports loose (see the note in “ASSEMBLING THE BOX”
above step 30), put them back in the cabinet now. Be careful to put them back in the same
position and orientation as when you drilled the pilot holes! If they were a tight fit before finishing,
they will be VERY tight now. Gently tap them into place with a hammer, or squeeze them into
place with a clamp, protecting the finish with a scrap of wood. Be sure they are seated as tightly
as possible.
2. Use the screw gun to drive four #6x1-1/4 wood screws (Part # SC61) through the ports and into
the cleats.
3. Install the feet, using the four little rubber feet (Part # FT03) and four sheet metal screws, pan head
Philips, #6x5/8 (Part # SC66.
160
Don’t over-tighten the screws; you’ll just squash the feet.
4. Use a hot soldering iron to melt a little hole through the grill cloth over the four mounting holes
near the corners.
161
5. Place the cabinet on its back and drop the completed baffle into the front. Orient the baffle so that
the hookup wire is facing the port with the hole.
162
160
161
162
Содержание 1x8 Cabinet
Страница 52: ......