Touch-MyDesign
Technical Support:
http://zennioenglish.zendesk.com
36
The available actions are:
Run scene
: the bus will be sent the order to run a scene, i.e., the
scene number set for the “Scene” parameter will be sent, decreased
by 1 according to the KNX standard, so that other devices linked to
the same object execute the corresponding scene (predefined joint
reaction).
Save scene
: the bus will be sent the order to run a scene, i.e., the
scene number set for the “Scene” parameter will be sent, increased
by 127 according to the KNX standard, so that other devices linked
to the same object replace the reaction previously defined for such
scene number.
Long press
: permits selecting the reaction when a long press takes place. It is
completely analogous to the above “Short press” parameter, so please refer to its
description for further information.
Threshold time
: defines the minimum time (in tenths of a second) that the push
button connected to the input of Touch-MyDesign should remain hold before the
devices understands it as a long press.
Response delay (after short press)
: defines a delay (in tenths of a second) to
be applied prior to sending the communication object corresponding to the short
presses. In other words, when a short press takes place, Touch-MyDesign will wait
for the time set for this parameter before sending the KNX bus the value of the
corresponding object. To obtain an immediate sending (with no delay), the value “0”
may be set here.
Response delay (after long press
): analogous to the previous parameter, but
referred to long presses.
Lock
: selecting “Yes” will display a new 1-bit communication object, “[Ix] Lock”,
that permits locking or unlocking the corresponding input (by sending the values “1”
or “0”, respectively). While the input remains locked, any order it sends will be
ignored.
