Touch-MyDesign
Technical Support:
http://zennioenglish.zendesk.com
15
Touch locking
. This function permits locking (i.e., making them useless) or
unlocking the touch buttons of the touch panel, with the possibility of setting the
following fields (from the “Touch locking” screen, which will become visible after
enabling this function; see
Locking method
: defines the desired procedure for entering into the
“locked” state. This can consist in a 1-bit object (“[General] Touch Lock”,
which will lock the touch buttons when it receives the values “1” or “0”,
according to the parameterization), the reception of a scene (values 1 to 64,
configurable) through “[General] Scenes: receive”; or an Auto (timed)
triggering which will require setting (through the “Time to lock” parameter, in
seconds) how much time the device must stay idle since the last button
touch before entering into the “locked” state.
Unlocking method
: defines the procedure for leaving the “locked” state of
the touch panel. This can consist in a 1-bit object (“[General] Touch Unlock”,
which will proceed with the unlock on the arrival of the values “1” or “0”,
according to parameterization) or in the reception of a scene (values 1 to 64,
configurable) through “[General] Scenes: receive”.
Figure 9
Touch locking (General)
Welcome Back object
. This function permits sending a certain value (binary
or scene) to the KNX bus when the user performs a touch on any of the touch
buttons after a standby period. This makes possible, for example, lighting up a
room after several hours of darkness with only a random touch over the touch
panel. If enabled, this function will make the “[General] Welcome Back object”
object visible, as well as a new window (see
) from where it is possible to
parameterize its behaviour.
