Touch-MyDesign
Technical Support:
http://zennioenglish.zendesk.com
23
3.3.2
INDIVIDUAL
In the case of selecting the option “Individual” in any of the drop-down lists from
the “Configuration” page of the “Main buttons” tab, two new pages (“Button X1” and
“Button X2”, where X is the letter of the pair for which the “Individual” option has been
selected) from where it will be possible to set the desired functionality of the buttons
and LEDs that constitute the corresponding pair.
Note
:
figures in this section may refer to the case of “Button A1”. Any other cases
should be analogous
.
Figure 14
Button A1 (Main buttons)
The parameters that are shown here by default are
Function
and
LED Lighting
, being
the latter conditioned by the option that has been selected for the former, which permits
the following options:
Disabled
: this option (disabled by default) entirely disables the functionality
of button Xi, however there will still be the possibility of selecting (through the
“LED indicator” parameter) whether the associated LED behaves regularly
(“Active”) and therefore turns on for an instant whenever a press happens on the
button (and afterwards turns off), or remains totally inactive.
1-bit
: permits sending a certain binary value, B (“0”, “1” or an alternating
value), through the “[Xi] Binary control: B” object, visible after assigning this
functionality to button Xi.
The parameter
LED lighting
permits, for its part, two alternatives for the
behaviour of the LED corresponding to the button:
Regular
: the LED will behave in the usual way: when a touch on its
button is detected, it will light (according to the custom “ON” level, in
parameterized) for an instant and it will then turn off again (according to
the custom “OFF” level, if parameterized).
