26
ZCM4821-001_v01
FITTING THE DRIP TRAY AND THE TRAY FOR LATTE MACCHIATO
●
First of all, centre and push the Macchiato tray from the front into the coffee machine
until it clicks into place. To remove, lift the front slightly and pull out.
●
Push the drip tray with the stainless steel grate into the coffee machine until it snaps
into place. Press at the front lightly towards the tray so that it slides slowly into the
position for use.
The Latte Macchiato rest allows the use of tall glasses for Latte Macchiato.
This rest cannot collect liquids.
FITTING THE AROMA BOX
If desired, it is possible to increase the capacity of the standard coffee bean container from
125 g to 250 g. To fit the aroma box, proceed as follows:
●
Remove the lid
(a)
of the coffee bean container by opening it to an upright position and
subsequently pulling it out of its holder.
●
Remove the lid
(b)
of the coffee powder bin by opening it to an upright position and
subsequently turning to the right or left to pull it out of its holder.
a
b
●
Put the aroma box onto coffee bean container.
Make sure that the grinder fineness levers are at the same position above
each other.
●
Fit the lid
(b)
of the coffee powder bin by inserting it into the holder and turning it into
position.
●
Fit the lid
(a)
of the coffee bean holder by inserting the hinge into the holder from
above. Both straps on the lid must be inserted into the
front
slot so they snap in.
b
a
CONNECTING THE MILK SYSTEM
The milk system must be connected in order to dispense coffee specialities with milk/
frothed milk. Proceed as follows:
●
Press the left side of the door with the coffee dispensing unit to open it.
●
Push the
straight cut end of the milk hose
through the side opening of the coffee
machine from the outside to the inside
1
.
1
3
2
●
Insert the end of the milk hose into the opening on the upper left of the milk frother
2
until it stops and press the milk hose into the guide
3
.
If you only wish to dispense hot water (e.g., for tea) the hose may not be
connected.
●
Close the door with the coffee dispensing unit.
●
Place a milk package to the left of the coffee machine.
●
Insert the milk hose into the opened milk package.
The slanted tube end should reach the bottom of the milk container.
In the case of newly opened, not yet completely filled milk packages, it is
possible that milk will drip out of the dispenser unit after preparation of
a coffee speciality.
Milk is a sensitive foodstuff. Always pay attention to cleanliness when
dealing with milk. Open milk packages with clean hands and tools to
prevent germs from getting into the milk.
USING THE MILK COOLER (OPTIONAL)
The milk cooler is supplied with two cool packs. One cool pack can be kept
in the freezer while the other is being used.
The cold packs are filled with a small amount of table salt. This has
a positive effect on the cooling time.
The cool pack must be replaced after approx. 5 hours to ensure consistent
cooling of the milk.
Preparing the cold pack:
●
Remove the screw plug and rubber stoppers of the cold packs.
●
Fill the cold packs with water and seal them again with the rubber rubber stoppers and
the screw plug.
Do not overfill the cold packs so that they do not burst on freezing.
Installing the milk cooler:
●
Place the milk cooler to the left of the coffee machine. Open the lid and place
one
precooled cold pack into the guide on the rear side.
●
Insert a milk container.
●
Insert the milk tube into the open milk container.
Содержание ZCM4821B
Страница 43: ...ZCM4821 001_v01 ...
