Zelmer ZCM4821B, Руководство пользователя

Страница: 36 / 44

36
ZCM4821-001_v01
●
Push the coffee dispensing unit upwards 1 .
●
Release the distribution hose on the door by pulling it lightly from the inside of the door
towards the outside 2 and pressing to the left 3 so that it clicks out of the fastener. The
dispensing unit can now be removed and the interior is easily accessible.
1
2
3
●
Thoroughly clean the coffee dispensing unit from the inside and outside with warm
water and a suitable brush to remove any coffee residue and prevent mould from
forming.
Disconnect and clean the hose distribution system of the coffee
dispensing unit (only if necessary, e.g, clogging), see section “CLEANING
THE HOSE DISTRIBUTION SYSTEM”.
●
Reinsert the coffee dispensing unit, see section “INSTALLING THE COFFEE
DISPENSING UNIT”.
CLEANING THE HOSE DISTRIBUTION SYSTEM
●
Grip the loose hose end near to the spring and pull the cross-shaped hose connector
1 out of its fixing. Subsequently pull both hose ends with the sleeve ends out of the
dispensing tubes 2 .
1
2
●
Pull the sleeves out of the hoses A and disconnect the hoses from the connecting
piece C . Pull the hose together with the spring C from the connecting piece.
●
Leave the parts immersed in a milk cleaning solution for several hours. Refer to the
instructions on the cleaning solution for the exact quantity.
●
Subsequently clean the parts with the solution and rinse them thoroughly with clean
water.
●
Push the hoses onto the connecting piece B and the sleeves into the hoses A . Insert
the hose with the spring push the hose and spring onto the connector C .
A
A
B B
C
D
A
C
The spring must be evenly pulled over the half of the hose and the funnel-
shaped end of the hose D must face upwards.
●
Now insert both sleeve ends (with the hoses) into the dispensing tubes 2 and press
them in until they snap in properly. Push the connecting piece into the fixing slot 1 and
subsequently push the hoses to the right and left under the frame 3 .
2
2
3
1
INSTALLING THE COFFEE DISPENSING UNIT
●
Place the coffee dispensing unit in the upper position back into the door and push the
unit slightly so that it audibly snaps in once.
●
Pull the hose from the inside through the door opening, press it to the right into the
holder and push the funnel-shaped part of the hose back into the collar until it fits
perfectly.
Now you can attach the coffee dispensing unit and close the door. When closing the door,
the dispenser should be located at the upper position, otherwise the milk tube will be
jammed.
CLEANING THE BREWING UNIT
The brewing unit must cleaned every week. If used intensively, more regular cleaning will
be necessary. If you do not intend to use your coffee machine for a longer period of time
(e. g., holidays), it is necessary to empty the waste container and the water tank and to
clean the brewing unit thoroughly.
Danger of burning! The dispensing unit may still be hot if you have
recently prepared coffee. Always allow the brewing unit to cool down
before cleaning.
To clean the brewing unit, proceed as follows:
●
Press the left side of the door with the coffee dispensing unit to open it.
●
Remove the waste container by pressing the container and pulling it out of the coffee
machine.