27
ZCM4821-001_v01
The slanted tube end must reach the bottom of the milk container.
FILLING WITH WATER
Milk, mineral water or other liquids can damage the water tank or the
coffee machine.
Only fill the water tank with fresh, cold water.
Observe the maximum filling level of 1.4 litres.
During initial startup (or when the water tank was previously emptied
completely), water intake can be slowed down. In this case, it is helpful to
switch the device off and on again.
To fill the water tank, proceed as follows:
●
Push the coffee dispensing unit into the uppermost position.
●
Press the water tank and pull it out of the coffee machine.
●
Fill the water tank with fresh water up to its maximum on the lower edge of the filling
hole.
1
2
3
4
5
6
7
8
9
10
11 12
FIL
TE
R T
IME
CON
TRO
L
IN
OU
T
●
Replace the water tank. Push it until it snaps in.
If the following warning appears on the display, the water tank must topped
up before the next drink is dispensed. Otherwise further function is not
possible:
Before inserting the water tank, make sure that it is dry on the out side.
Wipe the water tank shaft dry also before inserting the water tank. See also
section “PROBLEMS, POSSIBLE CAUSES AND REMEDIES”.
FILLING THE COFFEE BEAN CONTAINER
Every coffee machine is thoroughly checked before delivery. There fore,
there may be residual ground coffee in the grinder. Your coffee machine is
definitely new.
Make sure that no foreign objects such as stones get into the coffee bean
container. Damage caused by foreign objects in the grinder is excluded
from the warranty.
Fill the coffee bean container only with pure coffee beans without sugar
coatings or aromatised constituents.
To fill the coffee bean container, proceed as follows:
●
Fold back the lid of the coffee container.
●
Fill the container with fresh coffee beans.
●
Then close the container again.
Multifunction display
In this section, you will find an overview of the menus and the symbols used required to
operate the coffee machine.
The
selection buttons A - B - C each have different functions depending
on the menu selected.
Function-related key assignment:
During the settings, only those keys light up with which a logical command can be given
in the next step.
START DISPLAY
This menu appears when the coffee machine is switched on. You can select a function or
make settings for preparing coffee here.
A
B
C
A
Ground coffee quantity setting:
“extra light” to “extra strong”.
B
Selection of the dispensing
function: Coffee, coffee
specialities, hot water or
powdered coffee.
C
Cup size setting: espresso cup,
coffee cup or coffee mug.
M-BUTTON MENU
To display the M-button menu, press the
menu button. You can make changes to the
parameters of the coffee machine, start the service programme and retrieve information
here.
A
B
C
A
Scroll (left)
B
Confirm
C
Scroll (right)
To display a service programme, repeatedly press the buttons
A
and
C
until the desired
service programme appears in the selection frame and confirm by pressing the button
B
or the
button.
You can select from the following service programmes:
Descaling programme
This service programme runs the descaling
process. Refer to section
“RUNNING THE
DESCALING PROGRAMME”.
Cleaning programme
This service programme runs the cleaning
process. See section
“RUNNING THE
CLEANING PROGRAMME”.
Содержание ZCM4821B
Страница 43: ...ZCM4821 001_v01 ...