38
ZCM4821-001_v01
●
Remove the drip tray and empty it.
●
Push the drip tray into the coffee machine as far as indicated on the display.
The drip tray serves the purpose of collecting the cleaning water. Alternatively, you can
place a receptacle (> 350 ml) under the spout.
●
Then press the button
B
or the
button to continue with the cleaning process.
The programme performs several cycles. The following appears alternately on the display
during the cleaning process:
The brewing unit is positioned. The following then appears on the display:
●
Remove the drip tray and empty it.
●
Push the drip tray into the coffee machine as far as indicated on the display.
The drip tray serves the purpose of a collection receptacle. Alternatively, you can place
a receptacle (> 350 ml) under the spout.
●
Then press the button
B
or the
button to continue with the cleaning process.
The machine starts rinsing and the following appears on the display:
At the end of the cleaning process, the following appears on the display:
●
Remove the drip tray and empty it.
●
Push the drip tray into the coffee machine as indicated on the display.
●
Press the button
B
or the
button to complete the cleaning process. The following
appears on the display and flashes 3x to confirm:
The cleaning process is completed. The coffee machine is now ready for operation again
and returns to the last selected coffee mode.
The following appears on the display:
In the event of a power failure during the cleaning programme, the
programme has to be restarted.
RUNNING THE DESCALING PROGRAMME
The descaling programme enables simple and effective descaling of your coffee machine.
You should descale the coffee machine at regular intervals, but at least when the following
symbol appears on the display:
The descaling process runs in 2 phases, takes approx. 10 minutes and
should not be interrupted.
The frequency of descaling depends on the hardness of the water in your
region. Therefore please do not forget to determine the water hardness
and to set the corresponding hardness for the coffee machine! Please refer
to sections “DETERMINING THE WATER HARDNESS” and “SETTING AND
STORING THE WATER HARDNESS” for instructions on this.
Damage to the coffee machine and remnants still in the water by use of
the wrong descaler! Use only recommended descaling agents. If other
descaling solutions are used, manufacturer assumes no liability for any
damage caused.
Irritation to skin or eyes can occur if they come into contact with the
descaling solution! Avoid skin and eye contact.
Rinse off descaling solution with clean water. Obtain medical advice after
eye contact.
Damage to delicate surfaces can occur after contact with the descaling
solution. Remove any splashes immediately.
To run the descaling programme, follow the instructions on the display and proceed as
follows:
●
Press the
menu button. The following appears on the display:
●
Press the
A
or
C
buttons repeatedly until the “Cleaning programme” menu appears for
selection. The following appears on the display:
●
Press the button
B
or the
button to select with the descaling programme.
The following appears on the display:
●
Press the button
B
or the
button to start running the descaling programme.
Phase 1: Descaling
The following appears alternately on the display:
●
Remove the water tank.
●
Add the appropriate amount of descaling agent to the water tank (see the dispensing
instructions on the package). Then pour 250 ml of fresh water into the tank.
●
Replace the water tank.
●
Press the button
B
or the
button to continue with the descaling programme.
The brewing unit is positioned. The following then appears alternately on the display:
The programme performs several cycles. Intermittent pausing allows descaling to take
effect. The status is shown on the display.
Содержание ZCM4821B
Страница 43: ...ZCM4821 001_v01 ...
