Technical instructions
ZELIA ZLT
18
7.13. Accelerated mode
It may be necessary to perform tests to accelerate the internal clock of the
ZLT
. To do so:
1. Cut the power of the electrolyser via the ON/OFF button present on the power box.
2. Wait for about 30 seconds,
3. Press the button
and keep it held down,
4. Turn the electrolyser back on via the ON/OFF button on the power box.
5. Wait for the cell to display the start-up colors,
6. Release the button
,
7. You will observe that
td
is displayed, which confirms that the device clock has been accelerated.
8. Maintenance
8.1. Addition of salt
When the salt level falls below 2g/l, salt must be re-added to the tank.
The use of specially treated salt which contains stabilizing agents is recommended for the pool. The
effectiveness of the electrolyser will be significantly improved by it.
At the start of the season, we recommend that you check the salt rate and make sure it reaches 3g/l.
According to the measured salt rate, the amounts of salt to be added are as follows:
Weight of salt to add
(in kg)
to reach 3g/l:
Measured
rate/Tank vol.
20m3
40m3
60m3
1,5 g/l
30
60
90
2 g/l
20
40
60
2,5 g/l
10
20
30
For example, if the measured salt rate is 1.5g/l, 60 kg of salt should be added to reach a rate of
3g/l in a tank of 40m3
8.2. During winter
In winter, weather permitting, the treatment can be maintained by considerably reducing the fre-
quency. A filtration cycle of 8 hours every fortnight is enough in most cases.
However, it is essential to monitor the salt rate to keep the cell from functioning in water that contains
too little salt (<2g/l).
