Downloaded from www.vandenborre.be
4
LPG pipe holder
5
Natural Gas pipe holder
The appliance is set to default gas, to change the
setting choose pipe holder from the list. Always use
the gasket sealing.
Adjustment to different types of gas
Warning! Let only an authorized person do the
adjustment to different types of gas.
This appliance is for operation with natural gas.
With the correct injectors, you can also operate it
with liquid gas.
Warning! Before replacing the injectors, make sure
that the gas knobs are in the Off position. Let the
appliance cool off fully. There is a risk of injury.
Injectors replacement
Replace the nozzles when changing the gas type.
1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
3. With a socket spanner 7 remove the injectors and re-
place them with the ones which are necessary for the
type of gas you use.
4. To assemble the parts, do the same steps in reverse.
5. Replace the rating label (it is near the gas supply
pipe) with the one for the new type of gas supply. You
can find this label in the package supplied with the
appliance.
If the supply gas pressure is changeable or different from
the necessary pressure, you must fit an applicable pres-
sure adjuster on the gas supply pipe.
Adjustment of minimum level
To adjust the minimum level of the burners:
1. Light the burner.
2. Turn the knob on the minimum position.
3. Remove the control knob.
4. With a thin screwdriver, adjust the by-pass screw po-
sition. If you change from natural gas 20 mbar to liq-
uid gas, fully tighten the adjustment screw in. If you
change from liquid gas to natural gas 20 mbar, undo
the by-pass screw approximately 1/4 of a turn.
1
1
Minimum adjustment screw
5. Make sure the flame does not go out when you quick-
ly turn the knob from the maximum position to the
minimum position.
Oven injector replacement
1. Remove the bottom plate of the oven cavity (A) to get
access to the oven burner (B).
2. Release the screw (C) which keeps the burner in posi-
tion.
3. Carefully move the burner off the injector support (D).
Slowly move it to the left side. Make sure that the
burner bush stays on the burner mouthpiece. Do not
apply force to the wire of the thermocouple conductor
(F).
4. Release the injector (D) with a 7 mm socket spanner
and remove it. Replace it with the necessary one.
5. Assemble the burner in opposite sequence.
6. Replace the gas type sticker near the gas supply ramp
with the one related to the new gas type.
Minimum level adjustment of the gas oven burner:
1. Remove the oven control knob.
2. Adjust the adjustment screw (A) with a thin-bladed
screwdriver.
31
