YOKOGAWA FN510, Руководство пользователя

Страница: 37 / 67

<7. Setting Parameters>
7-2
IM 01W03D02-01EN
Table 7.1 Parameter Usage and Selection
Item Description
Tag No. Sets the Tag No. for Device Tag (software tag). The Tag No. can be set
sixteen characters (alphanumeric characters, including – ).
Output mode Allows outputting process value and self-diagnostic information via field wireless
network.
Either or all of sensor input (AI1/AI2/AI3/AI4 block: Process Value), and self-
diagnostic information (UAPMO block: Diagnostic Status) can be set output data.
Modbus device setting Sets the information about the Modbus device to be connected to the FN310.
Integral indicator display setting Sets the process value to display on the LCD.
Software write protect Prohibit writing the setting data.
Memo field Memo field available to write the check date, checker and others (as an adjustment
information), or anything.
Operational mode Set the operational mode of the sensor and integral indicator, etc.
NOTE
Some of the parameter setting are in the
dialogue form called method, by following
the on-line instructions you can configure the
parameters easily.
7.3 Setting Parameters
7.3.1 Parameter Usage and Selection
Before setting a parameter, please see the following
table for a summary of how and when each
parameter is used. FN310 supports a Modbus
device connection and each value of Modbus
device is assigned to AI1/AI2/AI3/AI4.
IMPORTANT
After setting and sending data with the field
wireless configuration tool or the device
configuration tool, wait 30 seconds before
turning off the FN310. If it is turned off too soon,
the setting will not be stored in the FN310.
7.3.2 Function Block and Menu Tree
(1) Function Block
The function of FN310 is shown below. Some
functions may not be available depending on the
device configuration tool used. When the device
configuration tool of our recommendation is
used, the software attached to the Field Wireless
Integrated Gateway or Field Wireless Management
Station is necessary for setting the dotted line part.
Refer to subsection 8.2 “Recommended Products
List” for the field wireless configuration tool of our
recommendation.
Function Block is depending on the connection
device type. Refer to section 9 “Connection Device
Type”.