YOKOGAWA DPharp EJXC40A, Руководство пользователя

Страница: 11 / 150

<2. Handling Cautions>
2-1
IM 01C25W05-01EN
2. Handling Cautions
The transmitters are thoroughly tested at the factory
before shipment.
When taking delivery of an instrument, visually
check them to make sure that no damage occurred
during shipment. Also check that all transmitter
mounting hardware shown in figure 2.1 is included.
If the transmitter is ordered without the mounting
bracket or with diaphragm seals, the transmitter
mounting hardware will not be included. This
chapter provides important information on how to
handle the transmitter. Read this carefully before
using the transmitter.
Horizontal pipe mounting
F0201.ai
U-bolt (L)
nut
Mounting bracket
50 mm (2-inch)
pipe
U-bolt (L)
U-bolt (S)
U-bolt (S)
nut
Figure 2.1 Transmitter Mounting Hardware
2.1 Model and Specifications
Check
The model name and specifications are written on
the name plate attached to the case. Look up the
GS (See Chapter 10) for model and suffix codes
and check that specifications are as you ordered.
When contacting Yokogawa, please also inform us
of this information.
F0202.ai
PRESSURE HIGH
Tag number
Serial No. & Diaphragm Seal System Code
PRESSURE LOW
Low pressure side transmitter (slave)
High pressure side transmitter (master)
Serial No. & DFS Accessary Model Code
Serial No. & Diaphragm Seal System Code
Serial No. & DFS Accessary Model Code
Read GS 01C25W05-01
Read GS 01C25W05-01
Figure 2.2 Name plate
2.2 Unpacking
Keep the transmitter in its original packaging to
prevent it from being damaged during shipment.
Do not unpack the transmitter until it reaches the
installation site.