10-70
IM 701310-01E
Setting the Clock Source
9.
Use the
rotary knob
and
SET
to set the clock to ON or OFF.
• If you select ON, proceed to step 11.
• If you select OFF, set the bit rate.
• Setting the Bit Rate
10.
Use the
rotary knob
and
SET
to select the bit rate from 1bps to 1Gbps.
Proceed to step 19 on page 10-71.
• Setting the Clock Source
11.
Use the
rotary knob
and
SET
to select the clock source.
Select the source from CH1 to CH4 or from M1 to M4.
12.
Use the
rotary knob
and
SET
to set the polarity to or .
Setting the CS
13.
Use the
rotary knob
and
SET
to set the CS to ON or OFF.
• If you select ON, set the CS state condition.
• If you select OFF, proceed to step 17 on page 10-71.
• Setting the State Condition
14.
Use the
rotary knob
and
SET
to select Setup under CS.
The CS dialog box appears.
15.
Use the
rotary knob
and
SET
to set the logic to AND or OR.
16.
Use the
rotary knob
and
SET
to set the state condition to compare with.
Set each signal state to H, L, or X. When you are done setting the states, press
ESC
to
return to the previous screen.
10.12 Searching Serial Pattern Signals
