YASKAWA CIMR-E7U Series, Техническое руководство

Страница: 48 / 83

E7 Drive Parameters 4-5
Monitor Registers (Read only)
The following table lists monitor parameters for the E7 drive. These parameters are used to monitor E7 drive information and cannot be written.
■ The “U-##” column contains the reference, if it exists, to the “U”, monitor, parameter displayed via the operator keypad.
■ The “Addr” column contains the register addresses for that parameter in hexadecimal format. E7 drive registers are always referred to
in hexadecimal format.
■ The “Function” column contains the register name.
■ The “Bit” column contains the list of available bits for that register. If the “Bit” column is empty, the register contains word data and
the individual bits are meaningless.
■ The “Description” column contains a short description of each register or register bit.
■ Reserved registers and data are meaningless and should be ignored
Table 4.3 - Monitor Registers (Read only)
U-## Addr Function Bit Description
0010h Inverter Status
0h @ RUN
1h Reserved
2h Reserved
3h @ Reset Signal
4h @ Speed Agree
5h @ Inverter Ready
6h @ Minor Fault
7h @ Major Fault
8h-Dh Reserved
Eh @ ComRef
Fh @ ComCtrl
0011h Operator Status
0 @ OPE
1 @ ERR
2 @ PRG Mode
3
0: Operator
1: PC
4h-Fh Reserved
0012h OPE
0h Reserved
1h OPE1 @ E7 drive kVA Setting Error
2h OPE2 @ Parameter Setting Out of Range
3h OPE3 @ Multi-Function Input Selection
4h Reserved
5h OPE5 @ Run Command Selection Error - Option board missing
6h OPE6 @ Control Method Selection Error - PG Opt Missing
7h OPE7 @ Multi-Function Analog Input Select Error
8h OPE8 @ Function Selection Error for current control mode
9h OPE9 @ PID Control Setup Error
Ah OPE10 @ V/F Parameter/Pattern Setting Error
Bh OPE11 @ Carrier Frequency Parameter Setting Error
Ch Reserved
Dh Reserved
Eh Reserved
Fh Reserved
0013h Inverter Product Code
0000h: G5
1000: V7
2010: E7
2020: E7C (YEC)
2030: E7A (YEG)
2040: E7U (YEA)
2050: G7C (YEC)
2060: G7A (YEG)
2070: G7U (YEA)
2080: VG7
2130: P7