model no.
060-0608-2
| contact us: 1.866.523.5218
72
MAINT
eNANC
e
GeNeRAl lUbRICATION
All bearings and bushings are permanently lubricated and require no maintenance.
Lubricating these parts will only result in the grease getting on to the friction wheel and disc
drive plate, which could damage the rubber clad friction wheel.
GeAR bOX lUbRICATION
Add grease to auger gear box every 50 hours, or every 2 years.
Tools Required:
–
Grease gun
–
#2 Phillips Screwdriver
1. Clean dirt off the zerk fitting (A) and
the M5 x 10 cross recessed bolt (B).
(Fig. 94)
2. Use a Phillips screwdriver to remove
the M5 x 10 cross recessed bolt (B).
(Fig. 94)
A
b
Figure 94
3. Use Low Temp NLGI #2 grease lithium
base in a grease gun.
4. Attach grease gun to zerk fitting.
(Fig. 95)
5. Add grease by 8 -10 pumps to push old
dirty grease out the bottom drain hole.
6. Stop pumping when fresh grease
comes out of the drain hole.
7. Reinstall the M5 x 10 cross recessed
bolt. Tighten until snug.
Figure 95
VAlVe CleARANCe
If set in summer: (if set at room temperature about 50°F – 86°F (10°C-30°C) intake
clearance 0.10~0.15 mm (.004”-.006”) exhaust clearance 0.15~0.20 mm (.006”-.008”)
If set in winter: (if set in cold at < 32°F (0°C) then recommend setting a little tighter at:
intake clearance 0.05~0.10 mm (.002”-.004”) exhaust clearance 0.10~0.15 mm
(.004”-.006”)
