model no.
060-0608-2
| contact us: 1.866.523.5218
32
OP
eRA
TION
befORe OPeRATION
CHECK THE GENERAL CONDITION AND MAKE REPAIRS:
–
Look around and underneath the engine for signs of oil or gasoline leaks.
–
Remove any excessive dirt or debris, especially around the muffler and recoil starter.
–
Look for signs of damage.
–
Check that all shields and covers are in place, and all nuts, bolts, and screws are
tightened.
CHECK THE ENGINE:
1. There is no fuel or oil in the engine. Fill with fuel and add 0W-30 prior to first use.
2. Check the fuel level (see ADD FUEL section).
3. Check the oil level (see CHECK/ADD OIL section).
OPeRATING SUGGeSTIONS
PREPARING FOR SNOW REMOVAL
IMPORTANT! Before the first snowfall, the area in which snow removal is to take place
should be cleared of all door mats, stones, sticks, etc., which might be picked up by the
auger and damage the snow thrower. Any obstacles should be marked to prevent the auger
from being driven into them.
To become familiar with the controls and machine, operate the snow thrower in a clear area
before re moving snow. The more familiar you become with the snow thrower the better
results you will have in its use.
WARNING: If snow clogs the discharge chute do not try to
remove it before:
–
Releasing the auger control handle.
–
Stopping the engine.
–
Disconnecting the cable from the spark plug.
Do not put your hand inside the chute or auger. Use the chute
clearing tool included with your snowblower.
