model no.
060-0608-2
| contact us: 1.866.523.5218
model no.
060-0608-2
| contact us: 1.866.523.5218
33
OP
eRA
TION
A light coat of wax may be applied to the inside surface of the auger housing, discharge
chute and deflector to prevent snow and ice from sticking. Be certain all controls are
disengaged, and engine is not running.
Allow 2 to 4 minutes of engine warm-up time before starting snow removal.
The best results are obtained when snow is removed as soon as possible after it falls, and
before it is packed down by driving or walking on snow.
SNOW CONDITIONS
Snow removal conditions vary so greatly from the first fluffy snowfall to the heavy wet snow
that operating instructions must be flexible to fit the type of snow removal encountered. The
operator must adapt the operation of the snow thrower to depth of snow, wind direction,
temperature, and snow conditions.
OPeRATING TIPS
1. Pay attention to your body to avoid over exertion and to avoid frost bite. Take breaks
indoors to rest & warm up.
2. Whenever possible discharge snow downwind.
3. Do not attempt to remove ice or hard packed frozen snow.
4. Always overlap each pass slightly to assure complete snow removal.
5. Remove snow one auger width beyond the pavement, to provide area for wind-blown
drifts to form to keep your pavement drift-free.
WARNING: Never start the engine until all the above measures
under assembly have been carried out.
–
Never use the snowblower without first reading and
understanding the instructions and all the warning and
instruction stickers on the machine.
–
Always use protective goggles or a visor during use,
maintenance and service.
NOTICe: The engine can be seriously damaged without oil.
Always check the oil level before using. The machine must stand
on level ground when checking.
engine key may be attached to the recoil starter grip. Please
remove the key from the recoil starter grip and attach/install
properly.
