For Service Engineers
Service Information
SI1906002E-001=YSP10 installation and adjustment procedures
51/120
11. Board transfer test
Set the machine line to the “skip” operation mode and have a test board transferred through the line
without mounting/print operation. Check that the board is transferred properly.
Note
Depending on the progress of the line installation, range of the line where board transfer test is
performed may vary. Check with the customer to confirm the test range.
Check that all the machines in the line to be tested can be powered on and available to run
automatically.
As for non-YAMAHA machines, check with the customer.
Select board data for board transfer test for all the machines to be tested.
If the board data does not exist, develop one. As for non-YAMAHA machines, ask the customer to
develop board data.
Set all the machines to be tested in the skip operation mode.
YAMAHA machines (Xg series and after)
Machine model
Application setting
All machines of Xg and
after
Open the VmSpec screen by pressing the [Machine] button in the application screen.
Select [Option Setting] (upper one) > [Special Function] and [Optional Function], and
select “None” respectively to disable the special/optional functions.
YSP10
Press the [Print] button in the application screen and open the [Board] tab. On the
parameter setting table, set [Print Execution] to “Skip”. When the optional inspection
function is installed, press the [Inspection] button in the application screen and open
the [Inspection] tab. Make sure that the [Inspection] setting is “Not Use”.
Mounters of Xg and after
Press the [Board] button in the application screen and open the [Mount] tab. Press the
[Edit] button at the upper part of the tab and specify skip operation in the provided
message box.
Dispensers of Xg and after
Press the [Board] button in the application screen and open the [Dot Dispense] tab.
Press the [Edit] button at the upper part of the tab and specify skip operation in the
provided message box.
Non-YAMAHA machines
Ask the customer to perform skip mode operation.
Adjust the conveyor width of all the machines to be tested.
As for YAMAHA machines, press the START button to adjust the conveyor width automatically. As for
non-YAMAHA machines, ask the customer to adjust the conveyor width.
Note
If the test board is Not put in from the upstream-most loader of the line, conveyor width of the
machine upstream of the machines to be tested should preferably be set. This will ease putting the
test board to the line.
Put in the test board from the upstream-most machine to be tested in the line.
Check that the test board is transferred properly and smoothly.
Make sure that the test board doesn’t get stuck at conveyor connecting part between machines.
