For Service Engineers
Service Information
SI1906002E-001=YSP10 installation and adjustment procedures
113/120
Message asking whether to save measured data is given:
Make sure that the displayed print offsets are within acceptable ranges as indicated below and fill in the
check sheet with the offsets.
Item
Acceptable range
dX
0 +/- 0.010
dY
0 +/- 0.010
dR
0 +/- 0.003
Message asking whether to adjust mask camera offsets is given:
Press the [Yes] button to adjust the offsets.
Note
If print offsets exceed acceptable ranges even after several times of adjustment, possible causes
and countermeasures are as follows:
Printing condition is unstable. Test-print several boards continuously and check printing
condition. Check print condition settings and mask condition.
Variation among adjustment boards used. Consider changing the adjustment board or use
only a single adjustment board through the adjustment.
Camera and image processing condition is unstable. Check condition of the adjustment board
and fiducial marks, also settings of step 16 and step 20.
Perform as follows as within acceptable ranges.
Print offsets are within acceptable ranges.
In response to the confirmation message shown below, press the [No] button and finish adjustment.
Print offsets exceed acceptable ranges.
In response to the confirmation message shown above, press the [Yes] button.
