Yamaha XJR1300(L) 99, Руководство по обслуживанию

Страница: 75 / 338

3-17
CHK
ADJ
CHECKING THE ENGINE OIL LEVEL/
CHANGING THE ENGINE OIL
CAUTION:
NOTE:
S
Engine oil also lubricates the clutch and
the wrong oil types or additives could
cause clutch slippage. Therefore, do not
add any chemical additives or use engine
oils with a grade of CD
a
or higher and do
not use oils labeled “ENERGY CONSERV-
ING II”
b or higher.
S
Do not allow foreign materials to enter the
crankcase.
4. Start the engine, warm it up for several min-
utes, and then turn it off.
5. Check the engine oil level again.
Before checking the engine oil level, wait a few
minutes until the oil has settled.
EAS00075
CHANGING THE ENGINE OIL
1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
S
engine oil filler cap
S
engine oil drain bolt 1
4. Drain:
S
engine oil
(completely from the crankcase)
5. If the oil filter element is also to be replaced,
perform the following procedure.
a. Remove the oil filter element cover
1
and oil
filter element 2 .
b. Check the O-ring 3 and replace it of it is
cracked or damage.
c. Install the new oil filter element and the oil fil-
ter element cover.
Oil filter element cover bolt
15 Nm (1.5 m
S
kg)
6. Check:
S
engine oil drain bolt gasket
Damage
Replace.
7. Install:
S
engine oil drain bolt
Engine oil drain bolt
43 Nm (4.3 m
S
kg)
8. Fill:
S
crankcase
(with the specified amount of the recom-
mended engine oil)