1-3
GEN
INFO
IMPORTANT INFORMATION
CAUTION:
EAS00023
LOCK WASHERS/ PLATES AND COTTER
PINS
After removal, replace all lock washers / plates
1
and cotter pins. After the bolt or nut has been
tightened to specification, bend the lock washer
tabs and the cotter pin ends along a flat of the
bolt or nut.
EAS00024
BEARINGS AND OIL SEALS
1. Install bearings and oil seals so that the
manufacturer’s marks or numbers are vis-
ible. When installing oil seals, lubricate the
oil seal lips with a light coat of lithium soap
base grease. Oil bearings liberally when
installing, if appropriate.
1 Oil seal
Do not spin the bearing with compressed air
because this will damage the bearing sur-
faces.
1 Bearing
EAS00025
CIRCLIPS
Before reassembly, check all circlips carefully
and replace damaged or distorted circlips. Al-
ways replace piston pin clips after one use.
When installing a circlip
1
, make sure that the
sharp-edged corner
2
is positioned opposite
the thrust
3
that the circlip receives.
4 Shaft
Содержание XJR1300(L) 99
