Yamaha XJR1300(L) 99, Руководство по обслуживанию

Страница: 139 / 338

4-27
ENG
CYLINDERS AND PISTONS
CAUTION:
NOTE:
NOTE:
EAS00254
REMOVING THE CYLINDERS AND PISTONS
The following procedure applies to all of the cyl-
inders and pistons.
1. Remove:
piston pin clip 1
piston pin 2
piston 3
Do not use a hammer to drive the piston pin
out.
Before removing the piston pin clip, cover the
crankcase opening with a clean rag to prevent
the piston pin clip from falling into the crank-
case.
For reference during installation, put an identi-
fication mark on each piston crown.
Before removing the piston pin, deburr the pis-
ton pin clip’s groove and the piston’s pin bore
area. If both areas are deburred and the piston
pin is still difficult to remove, remove it with the
piston pin puller
4 .
Piston pin puller
90890-01304
2. Remove:
top ring
2nd ring
oil ring
When removing a piston ring, open the end gap
with your fingers and lift the other side of the ring
over the piston crown.
EAS00260
CHECKING THE CYLINDERS AND PISTONS
The following procedure applies to all of the cyl-
inders and pistons.
1. Check:
piston wall
cylinder wall
Vertical scratches
Replace the cylinder,
and replace the piston and piston rings as a
set.
2. Measure:
piston to cylinder clearance